Call: 0123456789 | Email:

Shared power problems at Colocation Hosting

Server performance depends largely on the proper power supply. Power outages and interference will affect performance and cause damage to critical hardware, such as the motherboard, disk drives, and other memory devices. While everyone acknowledges this requirement and depends on location-sharing options to properly handle this factor, it would be surprising to know that many of these facilities are incomplete and can not provide the proper power systems that are constantly running.

Typical layoffs such as UPS, Stabilizers, Generators, Circuit Breakers, and other units that are evenly distributed performance must always be sufficiently maintained and provide sufficient support to ensure the smooth functioning of all servers and data centers.

Some of the problems are as follows:

a) No redundancy for the power grid – Multiple power distribution units connected to power supply networks and many uninterruptible power supply systems must have sufficient redundancy to cause unusual pins in the power supply and supply systems can lead to damage. However, this is often lacking in colocation centers and requires continuous maintenance.

b) No redundancy for the UPS – Strangely, some centers compromise on the base facility. They feel that given redundancy in the form of UPS, you do not have to do more. However, the redundancy of such systems is also important, as there are problems. This can happen if the UPS does not provide the backup immediately. Any delay may affect the network and need to create more UPS redundancy systems to avoid such situations. This redundancy is also capable of preventing overloading one UPS and helping to prolong its life. You can know the load on the uninterruptible power supply display system.

c) Failure of the switch switch to prevent system failure – Because some of the switching centers use the mechanical switches of the switches, sometimes it is not able to distribute and deliver the power at the right time causing an overload to the system. Circuit breakers are much more useful in handling such problems and need to be installed.

d) Insufficient generator capacity – In the event of a power failure, the generator, which operates on its own, must be strong enough to do so. The redundancy of a powerful generator is only necessary if the failure of the primary generator becomes necessary and every generator needs to be well served at the right time, with the exception of having enough fuel.

The above points should be carefully considered by the coordination centers to avoid network failures.

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *