Call: 0123456789 | Email: info@example.com

Falkeretek – How to Install Wallpaper Hardware


Here are some tips for attaching the hardware of the photo frame to the wall mounts

Two are mainly needed to install the hardware of the frame. First, you have to select the frames for the frame that you want to hang out. Second, put the hardware in place of the photo frame. Although it may seem super simple, it may be complicated. Here are some tips for installing the hardware of the photo frame on the wallet.

Step 1: Using the Right Picture Frame Hardware

If this is a good ready photo frame, no larger than 11×14 inches, the picture frame hardware usually comes in handy. If there is no hardware, a saw hook or two eyelids will solve the problem. These items can be found in the local hardware store

You should use a saw headset when the wall bracket is less than 11×14 inches as these can be easily installed. Sawdusted hangers are made of different sizes, so if your wooden frame is smaller than 8×10, small or medium-sized saw blades work well. Larger frames, such as 11×14 or 8×10, require larger saw hooks. For heavy frames or large frames, it is best to use eyebrows as they handle more weight or size than saw-hangers. The eyelids are a bit harder to install because they require more effort and require a few more steps.

Step 2: Determine how you want to close the frame

you want to hang up the wooden frame and begin installing the right photo frame hardware.

For saw-hangers, make sure that it is straight and narrow (or it will be difficult to hang the frame correctly). Measure the width of the frame, then split the measurement to place the saw hook. A small level can help to check whether the shoulder is right or not.

Instead, the eyelids are threaded into the frame casing to better handle the frame weight. To mount the eye hooks, screw the two hooks and tighten them through a wire. Before wrapping your eyelids, decide where to place them. Place pencil marks where the screws are going before you begin. The hooks must be screwed to the right and left sides of the frame. Measure 1/3 of the sides of the frame at the top and mark them – these are the spots where the eyelids penetrate. Pre-drill the holes when the spots are hit and then screw the eyelids. Route the eyelids in place through the wire. Make sure the hooks are even and use only the correct wire length to ensure that the frame is perfectly flat on the wall. Make sure you leave the chain in the cord – if it is too tightly threaded, the frame will not fit properly on the wall.

Attaching the hardware of the photo frame to these molds may seem somewhat complicated at first, but if you are well, it's easy enough. If you are not so sure, ask the box retailer to do the job for the first time. Then you can try your luck next.

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *