Call: 0123456789 | Email: info@example.com

Brother Laser Printer – Fax and Brother Multifunction Printer Error Codes and Their Recovery


Brother offers a full range of fax machines, printers, and multifunction printers. However, the list of common error codes found in them can disrupt the most experienced troubleshooter. Here are general bugs and bug fixes.

Error Code E50: Fuser Unit Damage

This may occur when the heat cylinder is destroyed or damaged. Make sure you replace the Brother laser printer with a new thermal roller

Error code E51: Laser beam fault

This error code indicates that the beam, mirrors or cover are not properly inserted. Make sure that these are for Brother Laser Printer Reactivity

S05 Error Code: Error Data Bus

This error code affects the data transfer of the parallel port.

"Machine Error" DTC: Board Problems

This type of error code is usually displayed with loud continuous beeps on the Brother Faxon machine. Check the soldering joints to make sure they are too cold at the power supply site. In addition, it is necessary to check that these joints take place on all other tabs before a change is made. If there is no improvement after the replacement, try to change the capacitors over the board.

"Black Pages"

Error Message This error code usually prints black pages on the Brother Laser Printer. This is usually done on the Brother 960 and Brother 1260 models. This means that HVPS is defective. Instead, replace the following diodes and replace the jumper wire. The diodes D31, D33, D30 and D32 need to be replaced. The jumper wire requires a track gauge 22.

Error Message: & quot; Checking Paper Tray & # 39;

An error is the paper path to be remedied by removing the paper feed paper. Then clean the paper eject rollers

"Cutter Problems" error message

This error message appears when a paper jam has occurred or the paper is not properly cut. Check whether the cutting spring is defective or not. Take care to remove the cutter and clean and then lubricate. If the problem persists, try replacing the gearbox.

"Poor copy quality" error message

Sometimes there may be some gray spots on the scanned paper. Make sure the glass and the scanning mirrors are clean. If they are clean, then the problem lies with the camera. You can try troubleshooting by pulling out the Brother fax machine for at least one full night. Worth to avoid swapping the camcorder

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *